HiPath / HiCom > HiPath - 3000 / 5000

Hipath 3008 - ISDN NETMOD Config

(1/2) > >>

octavian2l:
Hello

I have 3 devices like: http://www.openvox.cn/bbs/attachments/month_1005/20100508_46e506ce9ef3d9f303f6ZFr3HWrhIot1.jpg , called Intracom NETMOD.
From our telephony provider I have 3 ISDN BRA , 2 with head number and MSN and 1 just with head number. I talked with provider and they say:  "we have made permanent modification on LAY1HOLD parameter on our device". I have sound tone with the ports AB1 and AB2, but no sound with S0 port. The S0 port it's connected via RJ45 cable in STMD3 port.

Please help me to undersand how to check if the lines are in HIPATH3800 and how to setup hipath to split the head number and msn number to ports (internal analogic or digital).

Thanks.

Kimera:
Where the HiPath 3800 was installed (Country)?

Have you read the HiPath 3000 V9 Service Manual? there you will find all the information about STMD3 cabling/wiring to ISDN (BRA) access Network Terminator.

Which type of S0 your provider is giving you (Euro-ISDN, as example)?

Best regards,
Kimera.

octavian2l:
Hipath 3800 it is installed in Romania. I think it is Euro ISDN, i don't know.

I will read in manual , i just opened an made a fast search. STMD3 has in back that kind of connector  (8 plugs) as RJ45, it is not connected via patch panel. 

I don't know how to check if S0 it works.

Thanks

Alessandro - Telcom:
Maybe te first test that you have to do is connect an isdn phone to the 3 ISDN BRA. If you have rj45 connectors on the back of Hipath3000 the cabling is simply as lan cable, not crossed. You have to cross 1-2,4-5 only if you connect as Bus S0.

octavian2l:
hello

Alessandro  it is right, let me explain:


* ISDN  backpack connector 8 with RJ45 was not connected in the right Hipath Expansion Box Slot, it should be conected in 4 but it was conected in 5.
* Backpack conector was the version for Internal digital telephones. For ISDN need to be crossed
* ISDN line must be defined as S0 Euro CO PMP. See attach where you find this option
* I had also ISDN 2 GSM Device by Topex. (ISDN Bri Gateway). On this device the PORT TE must be conected with STMD3 via crossover ISDN cable, and SYNC PORT (clock signal synchronization port) must be conected in ISDN device. Manual it is here: http://www.topex.ro/en/get_file?idFile=3112
I  have an Siemens Optipoint 500 Advance  for Reception and phone extension does not work. In Hipath Manager I can program numbers. It is connected to 500 Advanced via cable on the correct port. I need to make something special for extension to function?

Navigation

[0] Message Index

[#] Next page